ZX14 TRUE Carbon Fiber Rear Hugger 2006 - 2015
2006 - 2011 ZX14
2012 - 2015 ZX14 may required make a small bracket for the RHS
Full Carbon Fiber Not over lay fiberglass
Feel Free to check out our other Carbon Fiber Parts in our ZX14 Carbon Fiber Section
Remove original chain guard. Remove screw holding front brake hose clip to swing arm.
Slide hugger into position and fit to original chain guard positions using M6 x 12mm socket flange
screws with nylon washers. Do not fully tighten.
Refit brake hose clip using M6 x 20rnm socket flange screw then fully tighten. Fit thick rubber washer to
protruding end of screw then fit through hole in hugger, secure using steel washer and nyloc nut. Extra
rubber washers can be used as spacers to centralize the hugger (see photo). Optional sticky rubber strip
is supplied to fix to swing arm under front ledge of hugger use only if vibration is a problem. Fully
tighten nyloc nut and socket screws making sure front ledge of hugger is sat flush on swing arm.
100% Carbon can take up to 6 weeks and when ordered customer willing to wait no changes